Rigid attachment points can no longer be aligned in the load direction after mounting. Therefore, they should only be used if loading in the prescribed pulling direction is guaranteed. This can practically only be achieved with single-leg attachment. In the case of loads contrary to the ring plane there is an increased risk of the attachment point unscrewing in the load direction. The eye bolt can then easily break under the load. The same applies to eye nuts.
for welding to excavators, cross bars, spreaders, etc.
Cookie settings
We use cookies to optimise our web page for you. By continuing to use the web page you agree to the use of cookies. Further information about cookies can be found in our data protection declaration.
Required cookies
Required cookies are mandatory for the basic functions of the website. Without these cookies, you will unfortunately not be able to use our website.
These cookies are always set when you use the website. No personal data is collected or stored.
Functional cookies
These cookies allow us to analyze website usage so that we can measure and improve its performance.
No personal data is collected or stored.
